6.8 Final audio setup
This is an overview for a correct audio set up depending on the usage. Ground the unused MIC.-R
input if unused.
6.8.1 For glider flights
• Press button AUD 2x for VOX: Set to VOX 10 (turn off) or open the intercom switch
(indicating “e”).
• Press button AUD 3x for TXm: Set to TXm**.
• Press button AUD 5x for EXT: Set to EXT 00 (turn off).
For dynamic microphones:
• Press button AUD 9x for MIC: Set to MIC-L to Level 11.
• Press button AUD 8x for SITxx: Set to SIT01 (turn to min.).
For Electret microphones:
• Press button AUD 9x for MIC: Set to MIC-L to a level (3 to 10) so that indication is just exceed-
ing half the maximum value.
• Leave the menu in position “L” (not AUTO).
6.8.2 For motor gliders dual seaters
For change mode (motoring & headset – gliding & dynamic microphone)
• Press button AUD 2x for VOX: Set to VOX 3. on condition for motoring.
• Press button AUD 3x for TXm: Set to TXm**.
• Press button AUD 5x for EXT: Set to EXT 00 (turn off), or on condition.
• Press button AUD 9x for MIC:
o Set MIC-L to level 5 or as required
o Set MC-R as required or to 1 if unused
o Select AUTO and leave menu.
6.8.3 For motor planes
• Press button AUD 2x for VOX: Set to VOX 3 (turn off).
• Press button AUD 3x for TXm: Set to TXm**, or on condition.
• Press button AUD 5x for EXT: Set to EXT 00 (turn off), or on condition.
• Press button AUD 9x for MIC:
o Set to MIC-Level 3 or as required
o Set MC-R as required or to 1 if unused.
• Leave the menu in position “L” (not AUTO).
To Next Page
Loading...