4.3.2 Frequency selection from favourites list
By pressing and operating the turning knob a specific favourite list position can be accessed
[xx] (xx = index 0 … 99). When frequency and station identifier have been defined, they will be dis-
played in the Standby and station identifier windows.
The favourite identifiers list can be sorted in alphabetic order (see 4.3.3 Storing and Editing Favour-
ites).
To exit this menu, press the key.
The selection procedure can be terminated with either the AUD or FREQ buttons. Without pressing
any of these buttons the unit will return to its normal operating mode after about 15 seconds.
4.3.3 Storing and editing favourites
Any displayed Standby Frequency can be associated with an identifier and both can be stored as fa-
vourites in the favourite list. The frequency and identifier of a favourite can be edited.
First press the button and go to the desired favourite list position to be edited using the turn-
ing knob (index [00 …99]).
Press the MEMORY button a second time and „–EDIT--„ will show up in the program window.
In the identifier window a blinking cursor will show up
under the extreme left character.
The turning knob selects the desired character.
The AUD button positions the curser one character to
the right. The DUAL button positions the cursor one
character to the left and simultaneously erases this
character.
The station identifier can consist of a maximum of 8
characters/spaces.
To change frequency just press the FREQ button and
follow the normal direct input procedure to edit the
frequency, see “4.3.1 Direct Frequency Selection”.
To quit the frequency input press the MEMORY but-
ton again in order to go to the station identifier win-
dow for editing the identifier if required. Using the buttons FREQ and MEMORY it is possible at any
time to toggle between identifier and frequency inputs.
Keep in mind the watch dog timer which will terminate the input mode after 15 sec.
To Next Page
Loading...
Need help?
General