Page 4-9 Installation Checkout TQG191-IM
Rev 0: 28 Feb 2019
4.3.7.2 Brightness
To modify the display brightness during operation, push the VFR button for at least 3 seconds.
When the menu appears, brightness can be adjusted by pushing the Rotary Knob and rotating it
to change the level.
Figure 4-8: Display Brightness Adjustment
4.3.7.3 GPS Data
Actual GPS data can be displayed when pushing the Toggle Button for at least 3 seconds.
Figure 4-9: GPS Data
4.4 CONFIGURATION SET-UP
KTX2 configuration is performed directly from the Primary Display; no external connections are
necessary. Once the configuration parameters have been entered and saved, they will remain in
the Transponder’s memory until changed.
4.4.1 Entering Set-Up Mode
1. To enter set-up mode, press the ID button during system startup. The following menus
will appear (2 pages):
Figure 4-10: Entering Set-Up Mode
To Next Page
Loading...
