Page vi TQG191-IM
Rev 0: 28 Feb 2019
ABOUT THIS MANUAL
SECTION 1 – GENERAL INFORMATION
This section provides the following information: unit configurations, unit functionality,
items required but not supplied with the unit, equipment specifications, installation
approval/limitations and TSO approvals.
SECTION 2 – INSTALLATION INFORMATION
This section contains instructions to locate, assemble and install the KTX2 as well as
information for unpacking equipment, and inspection procedure for in-shipment damage.
SECTION 3 – INSTALLATION INSTRUCTIONS
This section contains instructions for post installation setup, post installation and return
to service checkout.
SECTION 4 – INSTALLATION CHECKOUT
This section contains general flight line maintenance procedures. It includes periodic
maintenance, troubleshooting and instructions for the return of defective components.
SECTION 5 – MAINTENANCE
This appendix defines the electrical characteristics of all input and output signals.
DEFINITIONS OF WARNING, CAUTIONS AND NOTES
WARNING
Warnings are used to bring the Installer’s immediate attention to
potentially hazardous situations in which equipment damage or
personal injury may occur if the instructions are disregarded.
CAUTION
Cautions are used to alert the installer that equipment damage or a
deviation from the STC may occur if instructions are not followed to
the letter.
IMPORTANT INFORMATION
Important information is used to explain an installation step in greater
detail so that there will be no misunderstanding of the Installation
Instructions intent.
To Next Page
Loading...
Need help?
General
