12
The Calibration menu contains the following options:
• Calibrate
• Calbr. Values
Calibrate
To calibrate:
1. Use the arrow buttons to select the Calibrate option.
2. Press OK. The message “Calibration successful” displays.
3. The only option is BACK.
4. Press OK to display the Calibration menu.
Calbr. Values
To prevent measurement deviations caused by a calibration error, the TQC Sheen
Glossmeter must always be calibrated with the same holder. The calibration values
can be adjusted if a different calibration holder is used:
1. Use the arrow buttons to select Cabr. Values.
2. Press OK to display a list of calibration values for each scan angle.
3. Use the arrow buttons to select the scan angle for which you want to adjust
the standard calibration values.
4. Press OK. The scan angle and the previous standard value are displayed. The
digit after the comma is selected.
5. Press the arrow buttons to adjust the digit in groups of 10.
Note: The calibration values are in the calibration holder next to the glass plate.
3.3 Scan Limits
You can set scan limits for measurements that need to fall within a certain range.
Scan limits can be activated and deactivated. The scan limits are deactivated by
default and the values are set to 1 (minimum) and 100 (maximum).
1. Select Setup in the main menu.
2. Select Scan Limits and press OK. The scan angles, the scan limits and their
status display.
3. Use the arrow buttons to select the scan angle for which you want to set
ranges and press OK. The high and the low limits display. The low limit is
selected. The status of the scan limits for the selected scan angle are also
displayed ("on" or "off"). The right-top of the screen displays the scan angle for
which you are setting limits.
4. Use the arrow buttons to adjust the limit and press OK. The high limit is now
selected.
5. Use the arrow buttons to adjust the limit and press OK. The status ("on" or "off")
of the limits for this scan angle are now selected.
To Next Page
Loading...
Need help?
General
