13
6. Use the arrow buttons to select "on" to activate the scan limits or "off" to
deactivate the scan limits for this scan angle and press OK. The Scan Limits
menu displays.
L
m
ts
low high
► 20° 15 - 30 on
60° 40 - 55 off
85° 30 - 40 off
Back
Figure 3
‑
3 Scanning ranges
If the scan limits for a specific scan angle are activated and the measurement value
is between the limits, a displays after the measurement value. A displays if the
measurement value is lower than the Low Limit. A displays if the measurement
value is higher than the High Limit.
Scan limits are set for scanning without data logging but can also be set for
batches. For more information see section 5.2.
3.4 Password
Use this menu option to protect the Setup menu with a password. If the Setup
menu is protected by a password, Log in displays in the main menu instead of
Setup. The password always consists of four digits.
Activate/deactivate the password
1. Select Setup in the menu.
2. Select Password and press OK.
3. Use the arrow buttons to select Password on or Password off and press OK.
Change password
1. Select Setup in the menu.
2. Select Password and press OK.
3. Select Change password and press OK. The previously defined four-digit
password displays. The first position of the four-digit password is selected.
4. Use the arrow buttons to change the digit and click OK. The second digit is
now selected.
5. Repeat the above procedure for the second, third and fourth positions. You will
be asked if you want to save the password after the last digit has been entered.
6. Select YES to save the password and press OK. The Password menu displays
again.
Note: After the password has been activated, you must log in to change the
settings.
To Next Page
Loading...
Need help?
General
