6
2. Getting started with the TQC Sheen Glossmeter
The glossmeter is ready for use as soon as you unpack it. All you have to do is set a
few parameters such as language, date/time and scan angle. For more information
on these settings, see chapter 3. These settings can be protected by a password.
The operating buttons
The instrument has 4 buttons:
The SCAN button is used to scan surfaces. This is also the button that
powers the glossmeter on.
The "up" arrow button enables you to navigate upward through the
menu structure.
The "down" arrow button enables you to navigate downward through
the menu structure.
The OK button is used to confirm the selected menu option.
Starting the glossmeter
Press the SCAN button until the logo displays. When the logo disappears, the main
menu described in section 2.2 displays.
Note: The message "Calibration needed!" displays when the TQC Sheen Glossmeter
needs calibrating. For more information see section 3.2.
Note: The warning LOW BATTERY displays when the battery is low. The TQC Sheen
Glossmeter powers off within 10 seconds.
Note: The instrument also powers off automatically if a button has not been pressed
within 10 minutes. You can change this time. For more information, see section 3.7.
To Next Page
Loading...
Need help?
General
