20
3. Use the arrow buttons to navigate to diameter/s and press OK. The averages
and the standard deviation display for this batch.
5.4 Clear
Use this option to clear all measurement data in a specific batch.
1. Select a batch from the Log menu and press OK.
2. Use the arrow buttons to select Clear and press OK. The question “Clear all
data?“ and the name of the selected batch display.
3. Select YES and press OK. The Log menu displays on the screen.
Note: Deleted data cannot be retrieved; data is permanently deleted.
5.5 Rename
Use this option to change the name of a batch. A batch name has ten positions that
can consist of letters and digits.
1. Select a batch from the Log menu and press OK.
2. Use the arrow buttons to select Rename and press OK. The first letter of the
batch name is selected.
3. Use the arrow buttons to change the value and press OK. The second position
is now selected.
4. Repeat the above procedure for the remaining positions. After the last position
has been changed, the batch menu displays again.
To Next Page
Loading...
Need help?
General
