4.2 Language Selection
Metaware
The Metaware software comes with pre-installed language packs. To
select the language pack select ‘tools’ and then ‘language’ and select the
language of choice.
Instrument
The Instrument language can also be changed. To Change the language
follow the steps below:
• From the main menu, select System
• From the system menu, select Language
• Highlight required language and press <OK>
• Press <cancel> to return to main menu
4.3 Setting the Date and Time
The instrument has an internal calendar and clock which is used to date stamp
the results log. The clock may be set to UTC when you receive the instrument
so may need re-setting. It will also need re-setting if the battery is
disconnected. The clock can be set either through the Metaware or directly
on the instrument.
To set via Metaware, right click on the time pane at the bottom of the
Metaware window and click ‘set to computer date/time’.
To set the clock on the instrument, the instrument must first be disconnected
from the Metaware as the instrument controls are isolated when the Metaware
is running and the status is showing connected. To disconnect, navigate to
‘Metalyser’ via the tools/communications menu and click the Bluetooth logo.
The pain at the bottom left should show disconnected.
Metalyser® Field Pro HM3000 Instruction Manual v 5.0
To Next Page
Loading...
Need help?
General
