NOTICE:
Equipment damage!
Applying excessive voltage to the sensor will permanently damage it.
20 BAS-SVX10F-EN
Installation: All Models Other Than the Display Sensor
Installation: All Models Other Than the Display Sensor
This section provides step-by-step installation instructions for all sensor models other than the
display sensor. (For installation of the display sensor, see p. 10.) Read through the pr
e-installation
information before proceeding with the installation.
Note: Before installi
ng a wired sensor, ensure that a wire access hole is available at the sensor
location and the wire is accessible through the hole. The technician should assume that the
wires are attached to the appropriate unit controller, that there is continuity between the
location and the controller, and that the wires are accurately labeled or identified by color.
Mounting the Back Plate
WARNING
Hazardous Voltage!
Disconnect all electric power, including remote disconnects before servicing. Follow proper
lockout/tagout procedures to ensure the power can not be inadvertently energized. Failure to
disconnect power before servicing could result in death or serious injury.
1. Shut off power to th
e unit controller.
2. Remove the cover by firmly pressing
the thumb tab at the bottom of the cover and pulling the
cover away from the back plate.
To Next Page
Loading...