BAS-SVX40K-EN
27
shown in the following figure.
Figure 7. Connecting wiring harness
Blue = LINK +
Gray = LINK -
Black =
Red = +24 Vdc/ac
5. Route the wires from the WCI through either:
a. The opening in the back plate (part a of the following figure).
b. The bottom exit port (part b of the following figure).
Figure 8. Routing the wires through the WCI backplate or the WCI bottom exit port
6. Connect the wiring harness according to the illustration that is appropriate for your application.
WCI Installation
To Next Page
Loading...
