Trane Air-Fi WCS-SB/R - Page 55

BAS-SVX40K-EN
55
Table 10. WCS—SB/SD configuration options (continued)
Setting Configuration options
Fan
Note: Not all fan options are available
for all systems.
auto/off/low
med/high
auto/off/
low/high
auto/off
off/high (on) off/low/high off/low/
med/high
no fan options
enabled
auto/high (on)
Occupancy (timed override)
Temperature calibration offset
The reported temperature can be adjusted in increments of 0.1°F or 0.1°C, depending on unit configuration, to a
maximum of ±3.6°F (±2°C).
Adjustable in
increments of
0.1°F or 0.1°C
to a maximum
of ±3.6°F or ±2°C
Humidity calibration offset
Note: Available if the RH module is
installed on the WCS.
The reported humidity can be adjusted in increments of 0.1% RH to a maximum of ±5%RH.
Adjustable in
increments of
0.1%RH
to a maximum
of 5.0%RH
%
%
5. Review the display to ensure that you have selected the correct configuration options.
WCS-SB/SD Configuration