18-HH32D1-1C-EN
5
4. Install the large support clip to the adapter ring in the location
shown. The large clip has two grooves, so rotate the clip so that
the alignment tab indicated in Figure 5 faces the outside of the
ring.
Figure 5. Large Support Clip Position
Alignment
Tab
Large Support
Clip
5. Install plastic top to the adapter ring. See Figure 6.
a. Orient the plastic top so that the corner with the "bump out"
is on the control box corner of the unit as seen in Figure 6.
b. Align the screw hole locations in the plastic top with the
support clips, and make sure the plastic top is fully seated on
the adapter ring.
c. Attach the plastic top to the four support clips on the adapter
ring with four #12 screws. Hand tighten the screws.
Note: Do NOT over-tighten the screws.
Figure 6. Plastic Top Installation
GGeenneerraall DDaattaa
To Next Page
Loading...
