BCX-SVX002A-EN
45
Figure 34. Mounting leg installation for vertical units
and accessories
Figure 35. Mounting leg installation
Accessory Installation —
Mix Box, Angle Filter, Bottom Access
Filter, and Attenuators
Materials Provided:
• Mounting legs (2) for vertical units
• Accessory module and damper actuator cross over
harness (Mix Box)
Material Needed:
• #10 screws, for installing accessories to unit
• Eight #10 screws for mounting vertical legs to
accessory module. (16 Per Accessory)
• Four 1/4" 20 grade screws for mounting vertical legs to
floor. (8 Per Accessory)
• Two 3/8" nuts, washers and lock washers for installing
accessory horizontally in the ceiling with threaded rod.
(4 Sets Per Accessory)
All accessories ship separate for field installation. Lugs are
provided to suspend the accessories from the ceiling
horizontally.
Accessory Installation Procedure
1. Support the accessory independent of the unit in the
horizontal position.
Installation Mechanical
To Next Page
Loading...
