Trane BCHE - Installation - Controls; Displaying Setpoint or Temperature; Locking or Unlocking Settings

BCX-SVX002A-EN
79
Table 24. Configuration options for wireless display sensors
Setting Configuration Options
Temperature
• Choose Fahrenheit or Celsius
• Choose the degree resolution
(whole degrees, half degrees, or
tenths of degrees).
. .
.
.
.
.
Setpoint
No
setpoint
Single
setpoint
System
No system
options enabled
Fan
Note: Not all fan options are available
for all systems.
Auto/Off/Low
Med/High
Auto/Off/
Low/High
Auto/Off
Off/High (On) Off/Low/High Off/Low/
Med/High
No fan options
enabled
Connecting wires to
terminal
Occupancy (timed override)
Occupancy
enabled
Occupancy
disabled
Displaying Setpoint or Temperature
You can configure the sensor to display either the
temperature (default) or setpoint. To select either option:
1. Verify that the sensor is in operating mode and at the
home screen.
2. Press the up and down arrows for 3 seconds. The
arrow indicates setpoint display, as shown in the
following figure.
Figure 80. Displaying setpoint or temperature
Temperature Setpoint
Arrow indicates
setpoint display
Locking or Unlocking Settings
You can lock or unlock the setpoint, system, or fan setting
to prevent changes. To lock or unlock a setting:
Installation - Controls