6
MUA-SVX003B-EN
Receiving Instructions
Inspect shipment immediately when received to determine if any damage has occurred to the
crate during shipment.
After the unit has been uncrated, check for any visible damage to the unit. Check motor position
and turn blower wheel to determine if damage has occurred to these critical parts.
If any damage is found, the cosignee should sign the bill of lading indicating such damage and
immediately file claim for damage with transportation company.
Pre-Installation Instructions
Installer Please Note: This equipment has been test fired and inspected. It has been shipped free
from defects from our factory. However, during shipment and installation, problems such as
loose wires, leaks or loose fasteners may occur. It is the installer's responsibility to inspect and
correct any problems that may be found.
When the unit is received and uncrated, check the external data plate and all labels on the unit for
type of gas, electrical, and operational specifications to confirm that these agree with those at
point of installation. If the unit is equipped with an Outdoor Duct Furnace, also check the data
plate and all labels located inside each furnace.
Every rooftop unit will include an informational packet which will include the following: The
blower manual, outdoor duct furnace and evaporative cooler/cooling coil manuals (if applicable
to the unit order), wiring diagram(s), factory installed service convenience options manual (if
applicable to unit order) and special controls/data sheets.
NNoottee:: It is the owner's responsibility to provide any scaffolding or other apparatus required to
perform emergency service or annual/periodic maintenance to this equipment.
To Next Page
Loading...
