2.5.1
Lifting with forks
It is recommended to use a system to prevent the belts from
slipping from the bars during lifting.
Place spacers and protectors in between prevent damaging the
unit.
Insert the lifting bars into the arranged holes on the base and
indicated by the relative labels.
Lift the unit using suitable belts.
Make sure that all the equipment used for handling (belts, bars,
etc.) are appropriate for the weight of the unit.
Insert the forks from the side to avoid damaging the panels.
Before placing the machine on the ground remove the wooden
supports.
2.5.2
Lifting with a crane
During handling it is prohibited to exceed the maximum
inclination allowed, as shown in the figure.
A
Bar for lifting (maximum ø 63 mm)
B
Hole to insert the lifting bar
A Support
A Support
A
Bar for lifting (maximum ø 63 mm)
B
Hole to insert the lifting bar
To Next Page
Loading...
