A
Wooden support
B
Corner protector
A
Electrical board door
B
Front panel
2.6
Unpacking
Remove the wooden supports before resting it definitely on the
ground.
Remove the clear film that wraps the machine.
Remove the corner protectors.
The machine is supplied without shock absorbers. Install any
shock absorbers before resting the machine definitely on the
ground.
Only remove the packaging when set in the place of installation.
Unscrew the fixing screws and remove the panels.
To access the electrical board:
Remove the panels of the electrical board.
Set the disconnecting switch knob to Off.
Open the doors of the electrical board.
2.8
Resting on the ground
The unit must be positioned on a perfectly horizontal surface that is
able to withstand its weight.
Positioning must be performed slowly and so that all support points
are touching the floor.
2.7
Access to internal parts
A
Electrical board door
To Next Page
Loading...
