Place the unit on a perfectly level support surface.
Place a rigid rubber band between the base of the machine and the
support surface.
Installation, in addition to the indicated spaces, must enable access
to the authorised personnel for maintenance operations and must
take into account the safety distances from any other equipment
installed near the machine.
Verify that the support surface withstands the weight of the unit.
Provide a supporting slab of proportional dimensions with the
unit if resting on unstable ground.
The slab must be horizontal and able to withstand approximately
200% of the operating weight of the machine.
If necessary, use shock absorbers (rubber or spring).
3.4 Verifying clearances (clearance area)
To Next Page
Loading...
