Modify the value by using UP and DOWN buttons.
Press the ENTER key.
Select the Setpoint menu.
Press the ENTER key.
Press the ESC key to exit.
7.3.3
Set-point
The water temperature value (inlet water) can be set from the control
panel.
Press the ENTER key to access the main menu.
By using the UP and DOWN keys it is possible to choose the set-point
you wish to change: SH1 winter set-point.
Press the ENTER key to modify the value.
Use the UP and DOWN keys to modify the value.
Press the ENTER key to confirm.
Select the parameter menu.
Press the ENTER key.
Second set-point (accessory).
Select the adjustment menu.
Press the ENTER key.
The setting of second set-point value is password-protected.
The second set-point is a value expressed in Kelvin which indicates
the temperature difference of the set-point obtained by its enabling.
The value can be set and then, only for units equipped with the IAS
accessory (factory fitted accessory), enabled or disabled.
To Next Page
Loading...
