PTEC-M-1A
8
Unit Accessories
This unit is designed for through-
the-wall installation in new or
existing buildings. To complete the
installation of this PTAC, an
insulated wall sleeve and an outdoor
grille (either the stamped aluminum
grille or the architectural grille) are
required.
The chassis and the cabinet front are
shipped in one carton. Optional
accessories to complete a particular
installation are shown in Table 1.
Note: Consult sales literature for the
appropriate voltage and amperage
selections, if applicable. For
additional details and illustrations of
the accessories, refer to the catalog
or the particular installation manual.
General
Information
Table 1
Accessory
Wall Sleeve Kit Main Duct Kit
Heater Kit Subbase Kit
Architectural Grille Kit Extension Duct Kit
Hydronic Heat Kit Leveling Legs Kit
Stamped Grille Kit Wall Thermostat Kit
Power Vent Kit Hard Wire Kit
Deflector Grille Kit Drain Kit
Fuse Holder Kit Key Lock Kit
Power Switch Kit Filter Kit
Circuit Breaker Kit Remote Escutcheon Kit
Condensate Disposal Pump Kit Remote Temperature Sensor Kit
Water or Steam Valve Kit
To Next Page
Loading...
Need help?
General
