Trane RuptureGuard CDHF - Page 9

CTV-SVX06J-EN
9
Figure 8. Four-inch (101.6 mm) RuptureGuard valve assembly with spool piece kit contents
Table 2. Four-inch (101.6 mm) RuptureGuard valve assembly with spool piece kit contents
Quantity Item Description
Received
1 4 IN. RUPTUREGUARD VALVE ASSEMBLY WITH SPOOL PIECE
1
· ASSEMBLY/SPOOL PIECE; FLANGE, 4 IN.
—
1
· VALVE; RELIEF; 4 IN. RESEATABLE RELIEF
—
1
· CONTROL; HIGH-PRESSURE; 10 OP/6 CL
—
1
· EXCESS FLOW VALVE W/SLEEVE
—
1
· GAUGE; 0–60 PSI
—
1
· GASKET; FLANGE, 0.031 THK X 6.00OD X 4.82 ID
—
8
· NUT; HEX; 0.62-11
—
8
· SCREW; HEX, 5/8-11 X 2.75, HEX CAP
—
1
GASKET; FLANGE, 0.031 THK X 6.00OD X 4.82 ID
1
GASKET; FLANGE, 0.031 THK X 5.00OD X 3.68 ID
8
SCREW; HEX, 5/8-11 X 2.25, HEX CAP
1
BAG; FLAT, 9W OPNG X 12.50 LG X 3MIL W/TRANE LOGO
1
LABEL; LOGOS, NAMEPLATE
1 LITERATURE CTV-SVX06F-EN
1
GASKET; RUBBER; 0.125T X 5.25 OD X 3.75 ID
(a)
4
WASHER; 0.375 ID X 0.875 OD X 0.083 THK
(a)
4
SCREW; 3/8-16 X 2.25, HEX CAP
(a)
(a)
This item will be used if the chiller flange has ONLY four holes. Rubber gaskets are NOT for use on flanges with 5/8-in. (15.9-mm) threaded holes.
GGeenneerraall IInnffoorrmmaattiioonn