To Next PageTo Next Page
Need help?Do you have a question about the Trane Sintesis RTAF 245 SE SN LN and is the answer not in the manual?
Highlights potential hazards and safety considerations for users of the equipment.
Provides essential safety guidelines to prevent injury and equipment damage during maintenance.
Provides an overview of the RTAF unit's features, design, and operational capabilities.
Lists the tasks the contractor must perform for unit installation.
Recommendations for safely lifting and moving the unit.
Explains the three operating modes for free-cooling based on ambient and water temperatures.
Details requirements for sizing, selection, and installation of power supply wiring.
Details the components and operation of each refrigerant circuit.
Describes the screw compressor and its lubrication system components.
Details the procedure for isolating the refrigerant charge on the low side for servicing.
Details the procedure for adding oil to the compressor and system components.
Explains the information available to operators, technicians, and owners via the TD7 display.
Lists essential checks to be performed after installation and before initial start-up.
Details voltage requirements and checks for safe and proper unit operation.
Explains the importance of correct phase sequence for compressor rotation and safe operation.
Provides the sequence of operations for starting the chiller on a daily basis.
Provides procedures and recommendations for minimizing refrigerant emissions.
Highlights the importance of proper refrigerant and oil charge for unit performance.
Provides a timetable for recommended maintenance activities based on years or operating hours.
General