Trane SPLIT AC User Manual

22 48626782 rev 2
Contents
Error
Code
Error Description
Error Displayed on
Remote
Unit Response
Action to be
taken by user
-
Remote not in network
range
NETWORK NOT FOUND
Unit operates
as per previous
settings.
Remote must be
in network range
-
Connect to network (if
user did factory reset on
the remote)
CONNECT TO NETWORK
Unit operates
as per previous
settings
Contact service
technician
-
AC switched OFF (main
power OFF)
SET POINT TEMP +
INFRARED ACTIVATED +
NO NETWORK FOUND
Switch ON main
power/check the
plug
Lock with AC
- Lock not installed
NIGHT LATCH FAILED --
LOCK NOT INSTALLED
Lock is not in
network
- Night latch not operating
NIGHT LATCH FAILED --
PLEASE CHECK YOUR
LOCK
Change Battery
of Lock or Check
Lock is in Network
by doing Home/
Away Operations
- Door Open
NIGHT LATCH FAILED --
DOOR OPEN
Close door
Refer Section 2.3.1 for LED indications

Trane SPLIT AC Specifications

General

Type	Split AC
Cooling Capacity	Varies by model (e.g., 1.5 Ton, 2 Ton, etc.)
Energy Efficiency Ratio (EER)	Varies by model (typically ranges from 8.5 to 12.5)
Power Supply	220-240V, 50Hz
Refrigerant	R-410A
Noise Level (Indoor Unit)	Approximately 19-45 dB(A)
Noise Level (Outdoor Unit)	Varies by model (e.g., 50-60 dB(A))
Air Flow (Indoor Unit)	Varies by model
Dimensions (Indoor Unit)	Varies by model
Dimensions (Outdoor Unit)	Varies by model
Weight (Indoor Unit)	Varies by model
Weight (Outdoor Unit)	Varies by model