Trane Symbio 800 - Protocol Configuration; Lontalk Protocol Settings

8
BAS-SVP039C-EN
Protocol Configuration
To access the Symbio 800 Protocol Configuration page:
1. Connect to the Symbio 800 web interface.
2. On the left-hand navigation, click IInnssttaallllaattiioonn.
3. Click IIddeennttiiffiiccaattiioonn aanndd CCoommmmuunniiccaattiioonnss.
Figure 3. Identification and Communications
4. Click the PPrroottooccooll CCoonnffiigguurraattiioonn tab.
Figure 4. Protocol Configuration
5. View the existing Protocol Configuration settings.
NNoottee:: There are no LonTalk communication parameters to edit.
LonTalk Protocol Settings
The Symbio 800 controller supports LonTalk communications with the optional LonTalk module.
The LonTalk module is din rail mounted and is connected to the Symbio 800 controller using
USB.
NNoottee:: The Symbio 800 rotary addresses are not used with LonTalk communications.