What causes an intermittent display on Trane DC Drives?
An intermittent display on Trane DC Drives may be due to an overloaded power supply (SMPS) caused by improper control wiring or a fault within the frequency converter. If the display stays lit, the problem is likely in the control wiring. Check the wiring for shorts or incorrect connections. If the display continues to cut out, follow the procedure for a dark display.
How to stabilize motor speed on Trane TR200 DC Drives?
If the motor speed is unstable on your Trane DC Drives, it may be due to incorrect parameter settings. Check the settings in parameter group 1-6* Analog I/O mode. For closed loop operation, check settings in parameter group 20-0* Feedback.
What to do if Trane TR200 motor runs rough?
If the motor runs rough on your Trane DC Drives, it could be caused by over-magnetization. Check the motor settings in parameter groups 1-2* Motor Data, 1-3* Adv Motor Data, and 1-5* Load Indep. Setting.
Why won't my Trane TR200 motor brake?
General| Category | DC Drives |
|---|---|
| Model | TR200 |
| Output Voltage | 0-240 VDC |
| Protection Features | Overcurrent, Overvoltage, Short Circuit |
| Input Voltage | 200-240V AC |
To Next Page
