Section I - Off Season Cooling Operation
The Trane XL19i may be operated in the cooling mode to 45
o
F as shipped from the factory. These units
shall only be matched with variable speed air handling units and variable speed furnace / coil combinations.
The coils have factory supplied non - bleed TXV’s
Please refer to the accessory table below when determining if the XL19i will operate at the specified
conditions as well as required accessories.
ERUTAREPMETDO@SEIROSSECCADERIUQER
ledoM54
0
F04/03
0
F0
0
F
i91LX deppihSsACDE
toN
devorppA
Evaporator Defrost Control Kits (EDC)
Pg. 3
AY28X079 - Cooling only
AY28X084 - Heat pumps
The Trane XL19i is factory supplied with compressor crankcase heat
Compressor Crankcase Heater Kit - BAYCCHT
Compressor Hard Start Kits - BAYKSKT
XL19i’s are factory supplied with compressor start components.
To Next Page
Loading...
Need help?
General
