EasyManua.ls Logo

Transducer Techniques SSI - Page 42

Transducer Techniques SSI
48 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- 42 -
Battery charge indication ................ Battery symbol with 4 bars to show percent of full charge
4 bars = 80% - 100%, 3 bars = 60% - 80%, 2 bars = 40% - 60%, 1 bar = 20% - 40%,
flashing battery symbol = 0% - 20%
Relay Output
Relay types ......................................................... Dual relays with single common, solid state
AC rating ............................................... 120 mA @ 350Vac peak, 35 ohms series resistance
DC rating ........................................................ 120 mA @ 350Vdc, 35 ohms series resistance
Isolation to signal common ................................................................................. 5300 Vac rms
Setpoint setup .............................................................................................. Via keypad or PC
Response rate (selectable) ...... 60/second or 50/second (each 1 conversion or 256 samples)
Response filtering (selectable) ................................................................. Filtered or unfiltered
Active modes (selectable) ........... Above or below setpoint, latching or non-latching, disabled
Visual active Alarm Indication........................... AL1 LED (yellow), AL2 LED (red), Go (green)
Audible active alarm indication ................................................................................ Selectable
Activation time delay (selectable) ............................................................ 1 to 128 conversions
Setpoint / lockout modes (selectable) ................................... 1) Display and change setpoints
................................................................................... 2) Display but do not change setpoints
.................................................................................. 3) Neither display nor change setpoints
Serial Interface to PC
Signal type ................................................................................................................. USB 2.0
Baud rates (selectable) .............................. 300, 600, 1200, 2400, 4800, 9600, 19200, 38400
Serial protocol ................................................................. Point-to-point ASCII, PC compatible
Control Inputs
Number of inputs ....................................................................................................... 2 (A & B)
Input activation ................................................................................................ Short to ground
Control input action ............................. Meter Reset, Function Reset, Display Peak or Valley,
Tare, Tare Reset, Log
Mechanical
Dimensions .............................................................. 1.28” x 3.30” x 7.50” (32 x 84 x 185 mm)
Weight ................................................................................................................. 10 oz (280 g)
Case material .............................................................................................. ABS-94HB plastic
Provision for stand ..................................................... 3 inserts, 8-32 UNC threads, 3/8” deep,
1.500” triangle base, 1.750 triangle height (see photo on page 10)
Keypad .............................................................. Membrane type, 8-keys with tactile feedback
Display type ...................................................................................................... Reflective LCD
Displayed info ...... 6 large digits, 5 small digits, charge bargraph, units of measure, indicators
Electrical connectors .......................... DB9 male for TEDS and signal connection to load cell,
3-pin jack plus detachable connector for dual relay outputs
3-pin jack plus detachable connector for control inputs
10 foot (3 m) USB cable to charging unit or computer
Environmental
Operating temperature .......................................................................................... 0°C to 55°C
Storage temperature ......................................................................................... -20°C to 60°C
Relative humidity ....................................................... 95% from 0°C to 40°C, non-condensing
Environmental sealing ...................................................................Dust and humidity resistant

Related product manuals