16. Recall of internally stored readings to the meter display, a PC, or a printer with a
USB interface. Recall may be single or continuous (standard capability).
17. Recall of last meter calibration dates.
18. Data logging of time and date stamped values in real time via USB to a PC or printer.
The values may be the current reading, Peak, Valley, or any combination thereof.
19. Optional PC Data Logging Software, P/N SSI-DLS. Collects real-time or stored data
via USB. Lists, plots or stores meter data in PC memory.
20. Two built-in, solid state alarm relays, with LED and audible indications. Selectable
relay latching or non-latching, setpoint hysteresis or band deviation modes.
21. Two control inputs assignable to Meter Reset, Peak & Valley Reset, Peak & Valley
Display, Tare, Tare Reset, and Log Trigger.
22. Built-in load cell excitation voltage.
23. Powered by a rechargeable 2400 mAh lithium-ion battery for up to 65 hours of oper-
ation. Battery charge monitor circuit with 4-element bar graph charge monitor.
24. Selectable automatic meter shutoff after interval of inactivity (15, 30 or 60 minutes).
25. Wall plug type, UL-rated AC adapter / battery charger unit with removable A-B USB
cable.
26. Carrying case (optional).
To Next Page
Loading...
Need help?
General
