Traulsen INTELA-TRAUL - Basic Service Procedures; Adjusting The Temperature

Step 1: Press . Display will read “CUS.”
Step 2: Press . Display will read “000” with the left digit flashing.
Step 3: Press . Display will read “000” with the center digit flashing.
Step 4: Press until the center digit changes to an “A”.
Step 5: Press . Display will read “0A0” with the right digit flashing.
Step 6: Press until the right digit changes to an “1”.
Step 7: Press . Display will read “SPH”.
Step 8: Press again.
Step 9: Press or to adjust temperature to desired setting.
(NOTE: SPH should be set at 38 to 40 ° F for refrigerators and 0 ° F for freezers)
Step 10: When display reads the desired temperature press .
Step 11: Press until display reads “SPL”.
Step 12: Press .
Step 13: Press or to adjust temperature to desired setting.
(NOTE: SPL should be set at 34 ° F for refrigerators and -4 ° F for freezers)
Step 14: Press .
Step 15: Press to exit (R & A Series only). On G-Series models the
controller will automatically revert back to normal temperature display operation
after a delay of approximately 20-30 seconds.
SET
II. BASIC SERVICE PROCEDURES
The Display
Will Read
II. a - ADJUSTING THE TEMPERATURE:
SET
SET
SET
SET
SET
SET
SET
SET
-3-