14
•
SLEDGE
RADIO SYSTEM RULES
• Always turn your TQi transmitter on first and off last. This procedure
will help to prevent your model from receiving stray signals
from another transmitter, or other source, and running out of
control. Your model has electronic failsafes to prevent this type of
malfunction, but the first, best defense against a runaway model is
to always turn the transmitter on first, and off last.
• Always use new batteries for the radio system. Weak batteries will
limit the radio signal between the receiver and the transmitter. Loss
of the radio signal can cause you to lose control of your model.
• In order for the transmitter and receiver to bind to one another,
the receiver in the model must be turned on within 20 seconds
of turning on the transmitter. The transmitter LED will flash fast
red indicating a failure to link. If you miss it, simply turn off the
transmitter and start over.
• Always turn on the transmitter before plugging in the battery.
RADIO SYSTEM CONTROLS
RADIO SYSTEM BASIC ADJUSTMENTS
Steering Trim
The electronic steering trim located on the
face of the transmitter adjusts the neutral
(center) point of the steering channel.
Note: Traxxas Stability Management (TSM) must be completely
turned off while adjusting steering trim. See page 16 for TSM
adjustments.
Multi-Function Knob
The Multi-Function knob can be programmed
to control a variety of functions. From the
factory, the Multi-Function knob controls
Traxxas Stability Management (TSM). For more
detail on TSM, refer to page 16.
TRAXXAS TQ
i
RADIO SYSTEM
Stop immediately at the first
sign of weak batteries. Never
turn the transmitter off when
the battery pack is plugged
in. The model could run out
of control.
Remember, always turn the
TQi transmitter on first and
off last to avoid damage to
your model.
Forward
Neutral
Brake/Reverse
T
U
R
N
R
I
G
H
T
T
U
R
N
L
E
F
T
55
Always turn your
transmitter on rst.
Turn on the model.
11
22
Plug in the batteries.
33
To Next Page
Loading...
