19
EN
minipool Phantom PR1
U
Use
SPECIAL FUNCTIONS
SILENCE MODE
This function provides access to a page where the hours of the
day can be specied during which the control enters SILENCE
operating mode (silent hours), when all the automatic activa-
tions of the pumps and/or blowers are inhibited and only the
antifreeze safety function remains active.
The functions of whirlpool, blower and chromatherapy are
always available.
SILENCE mode setup is available after the programming cycle.
Use the
+
and
-
keys to change the hours, and then the
“OK” key to enable silent hours or disable the selection. The
silent hours are in white on a dark background.
After six seconds of inactivity, the setting is saved.
During SILENCE mode, the word "SILENCE" and the water
temperature alternate on the display.
0123 45
678910 11
12 13 14 15 16 17
18 19 20
DISABLE ENABLE
21 22 23
EXAMPLE
Hours of silence highlighted in the ta-
ble: silent mode activated from midnight
to 7 am and from 3 pm to 4 pm.
DISABLE (white boxes): silence mode
disabled
ENABLE (dark boxes): silence mode ena-
bled (recirculation inactive)
If the function is set, the word
"SILENCE" and the water tem-
perature alternate on the display.
If there is an alarm, the temperature and the alarm alternate.
BACKWASHING
ICON NOT ACTIVAT-
ED
This function is not available in Zen Active minipools, so the
icon is deactivated.
To Next Page
Loading...
