User manual TREMOL M23
8
Drawer
ECR has possibility to control cash drawer. The drawer is opened each time a
receipt is closed and when making received on account or paid out operations with the =
key. The drawer opening can be forbidden with parameter Drawer.
ECR POWER SUPPLY
Electricity mains supply
ECR is supplied by external adapter 9.6V/ 2.75A.
Supply by built-in accumulator batteries. Charging
ECR TREMOL M23 has option to work with built-in batteries type Li-Ion 7.4V
>2000mAh and must be mounted by service center. The accumulator charging is
automatic when the ECR is plugged to the electricity mains. Full charge cycle is about 10
hours. With fully charged accumulators ECR prints at least 2000 notes with single sale
each and can endure 12 hours in stand-by mode. To provide longest battery life follow
these rules:
1. Always charge the batteries to maximum level;
2. Once plugged out, plug in again after few hours work;
3. If the ECR is not used more than 30 days, remove the batteries. .
ECR CONSUMABLES AND THEIR REPLACEMENT
Depending on the ECR type two thermal paper rolls with following specifications: :
Paper roll replacement (feeding)
ECR monitors the availability of receipt and journal tapes and when it runs out of
either of them its operation is suspended and the message No PAPER is
displayed.
- Open the cover printer by lifting the lever.
- Remove the seals of the new tape. Place the tape with their heat-sensitive
surface down.
- Pull the loose end outside the groove and close the printer cover with slight
push.
- Press the ; key – the ECR resumes operation.
HOW TO USE THE PRESENT MANUAL
ECR operation manual provides numerous examples of its functions. The examples
follow a certain order, which is:
Text at the left of this symbol describes a concept, rule or function.
Text beside this symbol describes what is necessary to do to accomplish a function.
To Next Page
Loading...
