User's Manual
750 50 0045 03 42
10.5 Replacement of Battery Block
When the instrument autonomy is not sufficient anymore,
the battery block must be replaced :
1. Get a battery block from your TRIMOS agent (Trimos
réf.: 3704 0021).
2. Open the lid at the back of the display.
3. Remove the old battery block and replace it by the
new one (pay attention to the connector polarity).
4. Close the lid tightly.
5. Load the new batteries.
10.6 Recycling of Electronic Components
Disposal of Waste Electrical and Electronic Equipment (WEEE) applicable
throughout the European Union and other European countries with separate
collection programs
This symbol, found on the product or its packaging, indicates that it should not be
treated as household waste. It should be handed over to an official collection
point for the recycling of electrical and electronic equipment. A correct recycling
of this product will help to preserve the environment and the natural resources. For
more detailed information about the recycling of this product, please contact your
local authorities or your TRIMOS supplier.
10.7 Resetting of the Instrument
In case of blocking, it is possible to force the resetting of
the electronics. To do so, open the lid at the back of the
display and press the Reset button (1) with the tip of a
pencil.
10.8 Cleaning
The plastic parts, the display unit as well as the painted parts of the instrument should be
cleaned using a slightly dampened (watered) fabric. Clean the air cushion pads using a clean
fabric, slightly dampened with alcohol.
The use of solvents such as acetone, white spirit, trichloethylene, petrol or others
for cleaning must absolutely be avoided!
To Next Page
Loading...
Need help?
General
