TINYPRO6 – Operational Manual
TRINITY
[13]
To set the CT-primary, proceed the following instruction:
1. Press
key for about 4 to 5 seconds on Run Mode display.
2. The unit will alter into Programming Mode display with the settable parameter,
unit ADDRESS such as shown below.
3. Press
key. Immediately, P starts blinking with an interval of one second
which shows that the parameter is now settable. Set the ADDRESS by using
and keys until the desired value is received and then, press key
to confirm the set value.
4. Now, the unit will reset and return into Run Mode.
To Next Page
Loading...
