© 2023 All rights reserved.
pulse+direction/simulated encoder output, the analogue output may be set to a voltage
directly in software, using the DAC parameter
A 24V d.c. supply must be applied to I/O connector 1 to provide power for the analogue
output circuit.
LED DISPLAY
On power-up, the LEDs flash to show the MC403-X version and the SD card status.
P865 2 axis pulse output version:
3 flashes of the RED LED.
P866 1 axis servo version:
3 flashes of the GREEN LED.
P867 2 axis servo version:
3 flashes of both LEDs alternately.
SD card loading system software:
Both LEDs flash together until the system
SW load is completed.
During operation, the two LED’s show the processor (OK) and system status.
Display at start up Display with WDOG on Display Axis Error
To Next Page
Loading...
