Triton T70Z User Manual

3. With the cover off the
shower, turn the power
selector to the OFF
position (fig.15).
T70Z electric shower
16
IMPORTANT: Before finally fitting the cover,
the following steps must be taken:
a. Check the plumbing connections are
watertight.
b. Check the terminal block screws are fully
tightened.
1. With the cover off the
shower, turn the POWER
selector spindle clockwise
until the flat section is at
the bottom (fig.13).
2. With the cover off the
shower, turn the
stabiliser valve spindle
fully clockwise until
resistance is felt (fig.14).
4. With the cover off the
shower, turn the
temperature control so
that it goes to Maximum
HOT (fig.16).
c. Make sure the pipe and cable entering
the unit do not prevent the cover locating
correctly to the backplate.
d. Check the power selector is in the OFF
position and the temperature control is in
the MAXIMUM HOT position.
Fig.13
Fig.14
Fig.15
Fig.16
Flat section
to the
bottom
Stabiliser
valve

Triton T70Z Specifications

General

Brand	Triton
Model	T70Z
Category	Bathroom Fixtures
Language	English