24
General Information
Turn Indicators
When the indicator switch is
turned to left or right, the turn
indicator light will flash on and off
at the same speed as the turn indicators.
High Beam
When the ignition is switched on
and the headlight dip switch is set
to 'high beam', the high beam
warning light will illuminate.
Neutral
The neutral warning light indicates
when the transmission is in neutral
(no gear selected). The warning
light will illuminate when the transmission is
in neutral with the ignition switch in the ON
position.
Low Fuel
The low fuel indicator will
illuminate when there are
approximately 4.5 litres of fuel
remaining in the tank.
Alarm
The alarm light will illuminate
when the conditions described in
the accessory alarm instructions
are met.
ABS (Anti-Lock Brake System)
Indicator light
The ABS indicator light illuminates
to show that the ABS function is
not available. Illumination is
normal after engine start-up, and
until the motorcycle first reaches a speed
exceeding 6 mph (10 km/h). Unless there is a
fault, it should not illuminate again until the
engine is restarted.
If the indicator light becomes illuminated at
any other time while riding it indicates that
the ABS has a malfunction that requires
investigation.
See also Braking on page 41 .
If the ABS is not functioning, the brake
system will continue to function as a non
ABS braking system. Do not continue to
ride for longer than is necessary with the
indicator light illuminated. Contact an
authorised Triumph dealer as soon as
possible to have the fault checked and
rectified. In this situation braking too hard
will cause the wheels to lock resulting in
loss of control and an accident.
To Next Page
Loading...
Need help?
General
