EasyManuals Logo

Triumph Rocket III Handbook

Triumph Rocket III
104 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #77 background imageLoading...
Page #77 background image
77
Maintenance and Adjustment
Tyres
1. Wheel marking
2. Tyre marking
This motorcycle is equipped with tubeless
tyres, valves and wheel rims. Use only tyres
marked 'TUBELESS' and tubeless valves on
rims marked 'SUITABLE FOR TUBELESS
TYRES' .
Tyre Inflation Pressures
Correct inflation pressure will provide
maximum stability, rider comfort and tyre life.
Always check tyre pressures before riding
when the tyres are cold. Check tyre
pressures daily and adjust if necessary. See
the Specification section for details of the
correct inflation pressures.
Tyre Wear
As the tyre tread wears down, the tyre
becomes more susceptible to punctures and
failure. It is estimated that 90% of all tyre
problems occur during the last 10% of tread
life (90% worn). It is therefore not
recommended to use tyres until they are
worn to their minimum.
Minimum Recommended Tread
Depth
In accordance with the periodic maintenance
chart, measure the depth of the tread with a
depth gauge, and replace any tyre that has
worn to, or beyond the minimum allowable
tread depth specified in the table below:
Warning
Incorrect tyre inflation will cause abnormal
tread wear and instability problems that
may lead to loss of control and an accident.
Under-inflation may result in the tyre
slipping on, or coming off the rim.
Over-inflation will cause instability and
accelerated tread wear.
Both conditions are dangerous as they may
cause loss of control leading to an accident.
Under 130 km/h
(80 mph)
2 mm (0.08 in)
Over 130 km/h
(80 mph)
Rear 3 mm (0.12 in)
Front 2 mm (0.08 in)

Table of Contents

Other manuals for Triumph Rocket III

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Triumph Rocket III and is the answer not in the manual?

Triumph Rocket III Specifications

General IconGeneral
Compression Ratio10.0:1
Final DriveShaft
Transmission5-speed
Rear BrakesSingle 316mm disc, 2-piston caliper
Front Tire150/80 R17
Rear Tire240/50 R16
Dry Weight320 kg (705 lbs)
Fuel SystemElectronic fuel injection
Exhaust3-into-1 into 2
ClutchWet, multi-plate
FrameTubular steel, twin spine
Rear SuspensionTwin shocks, adjustable preload
Front BrakesTwin 320mm floating discs, 4-piston calipers
Front Wheel17 x 3.5 in
Fuel Tank Capacity24 liters (6.3 US gal)
Engine TypeLiquid-cooled, DOHC, in-line 3-cylinder

Related product manuals