Triumph Rocket III Handbook

91
Maintenance and Adjustment
Washing
Prepare a mixture of cold water and mild
automotive cleaner. Do not use a highly
alkaline soap as commonly found at
commercial car washes because it leaves a
residue.
Wash the exhaust system with a soft cloth. Do
not use an abrasive scouring pad or steel
wool. They will damage the finish.
Rinse the exhaust system thoroughly.
Ensure no soap or water enters the exhausts.
Drying
Dry the exhaust system as far as possible with
a soft cloth. Do not run the engine to dry the
system or spotting will occur.
Protecting
When the exhaust system is dry, rub
'Motorex 645 Clean and Protect' into the
surface.
It is recommended that regular protection be
applied to the system as this will both protect
and enhance the system's appearance.
Caution
The use of products containing silicone will
cause discolouration of the chrome and
must not be used. Similarly, the use of
abrasive cleaners will damage the system
and must not be used.

Triumph Rocket III Specifications

General

Compression Ratio	10.0:1
Final Drive	Shaft
Transmission	5-speed
Rear Brakes	Single 316mm disc, 2-piston caliper
Front Tire	150/80 R17
Rear Tire	240/50 R16
Dry Weight	320 kg (705 lbs)
Fuel System	Electronic fuel injection
Exhaust	3-into-1 into 2
Clutch	Wet, multi-plate
Frame	Tubular steel, twin spine
Rear Suspension	Twin shocks, adjustable preload
Front Brakes	Twin 320mm floating discs, 4-piston calipers
Front Wheel	17 x 3.5 in
Fuel Tank Capacity	24 liters (6.3 US gal)
Engine Type	Liquid-cooled, DOHC, in-line 3-cylinder