Triumph Rocket III Handbook

38
How to Ride the Motorcycle
To Stop the Engine
1. Engine stop switch
2. Ignition switch
3. Starter button
Close the throttle completely.
Select neutral.
Turn the ignition switch off.
Select first gear.
Support the motorcycle on a firm, level
surface with the side stand.
Lock the steering.
To Start the Engine
Check that the engine stop switch is in the
RUN position.
Ensure the transmission is in neutral.
Turn the ignition switch on.
Note:
• When the ignition is switched on,
the speedometer and tachometer
needles will quickly sweep from
zero to maximum and then return
to zero. The instrument warning
lights will illuminate and will then
go off (except those which
normally remain on until the
engine starts – see 'Warning
Lights' on page 23). It is not
necessary to wait for the needles
to return to zero before starting
the engine.
cbmp
2
1
3
Caution
The engine should normally be stopped by
turning the ignition switch to the OFF
position. The engine stop switch is for
emergency use only. Do not leave the
ignition switched on with the engine
stopped. Electrical damage may result.

Triumph Rocket III Specifications

General

Compression Ratio	10.0:1
Final Drive	Shaft
Transmission	5-speed
Rear Brakes	Single 316mm disc, 2-piston caliper
Front Tire	150/80 R17
Rear Tire	240/50 R16
Dry Weight	320 kg (705 lbs)
Fuel System	Electronic fuel injection
Exhaust	3-into-1 into 2
Clutch	Wet, multi-plate
Frame	Tubular steel, twin spine
Rear Suspension	Twin shocks, adjustable preload
Front Brakes	Twin 320mm floating discs, 4-piston calipers
Front Wheel	17 x 3.5 in
Fuel Tank Capacity	24 liters (6.3 US gal)
Engine Type	Liquid-cooled, DOHC, in-line 3-cylinder