7
Foreword - Safety First
Parts and Accessories
Triumph does not accept any liability
whatsoever for defects caused by the fitting
of non-approved parts, accessories or
conversions or the fitting of any approved
parts, accessories or conversions by
non-approved personnel.
Maintenance/Equipment
Owners should be aware that the only
approved parts, accessories and
conversions for any Triumph motorcycle
are those which carry official Triumph
approval and are fitted to the motorcycle
by an authorised dealer.
In particular, it is extremely hazardous to fit
or replace parts or accessories whose fitting
requires the dismantling of, or addition to,
either the electrical or fuel systems and any
such modification could cause a safety
hazard.
The fitting of any non-approved parts,
accessories or conversions may adversely
affect the handling, stability or other aspect
of the motorcycle operation that may result
in an accident causing injury or death.
Consult your authorised Triumph dealer
whenever there is doubt as to the correct
or safe operation of this Triumph
motorcycle.
Remember that continued operation of an
incorrectly performing motorcycle may
aggravate a fault and may also
compromise safety.
Use of a motorcycle with bank angle
indicators worn beyond the maximum limit
(when the bank angle indicator is worn to a
minimum of 5 mm in length) will allow the
motorcycle to be banked to an unsafe
angle. Therefore, always replace the bank
angle indicator pegs when they are worn to
5 mm in length. Banking to an unsafe angle
may cause instability, loss of motorcycle
control and an accident.
To Next Page
Loading...
Need help?
General
