21
General Information
To switch between the trip meter, clock and
range to empty display modes, press the
'scroll' button repeatedly until the desired
display is visible. The display will scroll
through in the order:
• Trip meter 1
• Trip meter 2
•Clock
• Range to empty
Trip Meter Reset
To reset either of the trip meters, select and
display the trip meter to be zeroed. Then
press and hold the 'scroll' button for
4 seconds. After 4 seconds, the trip meter on
display will reset to zero.
Range to Empty
This is an indication of the predicted distance
that can be travelled on the remaining fuel in
the tank.
Clock Adjustment
To reset the clock, select the clock display.
Then press and hold the 'scroll' button for
4 seconds, the clock’s hour display will start
to flash, release the 'scroll' button.
To reset the hour display, ensure the hour
display is still flashing then press the 'scroll'
button to change the setting. Each individual
button press will change the setting by one
digit. If the button is held, the display will
continuously scroll through in single digit
increments.
When the correct hour display is shown,
release the 'scroll' button for 4 seconds. The
minutes display will begin to flash. The
minutes display is adjusted in the same way
as for the hour display.
Once both hours and minutes are correctly
set, release the 'scroll' button for 4 seconds
and the display will cease to flash.
Warning
Do not attempt to adjust the clock with the
motorcycle in motion as this may lead to
loss of motorcycle control and an accident.
To Next Page
Loading...
