31
General Information
Seat Retainers
1. Rear fixing and reflector
2. Side fixings
To remove the seat, remove the rear fixing,
with the reflector, and the two side fixings.
Lift the seat up at the back for complete
removal from the motorcycle.
Seat Care
To prevent damage to the seat or seat cover,
care must be taken not to drop or lean the
seat against any surface which may damage
the seat or seat cover.
To refit the seat, engage the seat’s tongue
under the fuel tank, fit and tighten the side
fixings to 15 N m .
Fit the rear fixing, with the reflector, and
tighten to 9Nm.
22
1
cena
Caution
To prevent damage to the seat or seat
cover, care must be taken not to drop the
seat. Do not lean the seat against the
motorcycle or any surface which may
damage the seat or seat cover. Instead,
place the seat, with the seat cover facing
upwards, on a clean, flat surface which is
covered with a soft cloth.
Do not place any item on the seat which
may cause damage or staining to the seat
cover.
Warning
To prevent detachment of the seat during
riding, after fitting always grasp the seat
and pull firmly upwards. A loose or
detached seat could cause loss of
motorcycle control and an accident.
To Next Page
Loading...
