How to Ride the Motorcycle
154
Deactivation
The hill hold control system will
automatically deactivate when it detects
that the rider is attempting to move off.
The system will progressively release
the rear brake to assist the rider in
moving off.
The hill hold control system can also be
manually deactivated by a second firm
squeeze of the front brake lever.
The message HILL HOLD DEACTIVATED
will be displayed briefly in the
multifunction display.
Hill Hold Unavailable Message
If when attempting to activate the hill
hold control system, the message HILL
HOLD UNAVAILABLE - CHECK MANUAL is
displayed, this indicates one or more of
the following:
• The activation conditions described
on page 153 have not been met.
• There is a fault with the ABS or
engine management systems and
the ABS and/or MIL warning lights
are illuminated. See Warning Lights
on page 59.
The hill hold control system can be
enabled or disabled (see Bike Setup on
page 47).
Parking
Warning
Gasoline is extremely flammable and
can be explosive under certain
conditions. If parking inside a garage or
other structure, be sure it is well
ventilated and the motorcycle is not
close to any source of flame or sparks.
This includes any appliance with a pilot
light.
Failure to follow the above advice may
cause a fire resulting in damage to
property or personal injury.
Warning
The engine and exhaust system will be
hot after riding. DO NOT park where
pedestrians and children are likely to
touch the motorcycle.
Touching any part of the engine or
exhaust system when hot may cause
unprotected skin to become burnt.
To Next Page
Loading...
Need help?
General
