216
Preparation after Storage
Install the battery (if removed) (see
page 197).
If the motorcycle has been stored for
more than four months, change the
engine oil (see page 170).
Check all the points listed in the Daily
Safety Checks section.
Before starting the engine, remove the
spark plugs from each cylinder.
Put the side stand down.
Crank the engine on the starter motor
several times until the oil pressure light
goes out.
Reinstall the spark plugs, tightening to
9 lbf ft (12 Nm), and start the engine.
Check and if necessary correct the tire
pressures.
Clean the entire vehicle thoroughly.
Check the brakes for correct operation.
Test ride the motorcycle at low speeds.
To Next Page
Loading...
