P. 38 — User manual V3
Level 4
This mode will allow you a faster and more
powerful acceleration, allowing you to reach
32km/h
Level 5
This mode gives you access to the maximum
power assistance the motor can provide, up
to 32 Km/h. The rider should be ready for a
stronger sharp acceleration.
This is recommended for steeper inclines
when a maximum boost from the motor is
needed.
Not recommended for beginners.
No-Pedalling mode
From a stop or while in motion, simply twist
the Throttle Handle (on the right) to move
forward. To reach the top of some hills, it
may be necessary to pedal as well.
Note that the throttle is limited to the top
speed of the power assist level that you are
using.
Depending on local regulations the No-
Pedalling mode might not be available
in some areas!
Battery range is dependant on the type
of roadway, the number of hills and their
steepness, the speed and direction of the
wind, tire pressure, and the weight of the user.
Manual mode
In assistance mode, when you select level
0 on the LCD Screen, the power assistance
and the throttle remain inactive, but you will
have access to the Panel information such
as speed, distance, etc.
Cruise control
This mode allows you to maintain a steady
desired speed without pedalling.
To activate Cruise control mode
Twist the Throttle Handle (on right
handlebar) until the desired speed is
reached, maintain this speed for a few
seconds then press the button until
you see a “C” on the LCD Screen. Then you
can release the throttle and button and the
Cruise control mode is activated.
To deactivate the Cruise Control, simply
press one of the brake levers or use the
throttle.
Walk assist mode
The walk assist mode is useful when the
rider is walking alongside of the tricycle and
a bit of extra power is needed to push it up
an incline or an access ramp, or if carrying
heavy cargo. Walk assist mode is limited to
4km/h
When Walk Assist mode is activated the
motor engages immediately and propels
the tricycle forward at 4 km/h. Always
make sure the path is clear in front and
hold firmly onto the handlebars. The
motor will disengage as soon as the +
button is released or a brake lever is
pulled.
To Next Page
Loading...