Important Notes
1) If you try to access your own camera(s) from your home using the external IP address it may not work. Some
internet service providers recognize that you are trying to do something that usually doesn’t make sense.
Their routers may block requests that go from your network out to the internet and then loop back to your
own network.
Therefore we always recommend that you get in touch with a friend to help you test the remote access to
your camera from outside your own network. Or you can use an iPhone in 3G mode (Wi-Fi turned off)
2) Once your camera is live on the internet, you should change the admin password to something only you
would know. See the “User management” menu under “Tools” section of your camera’s “Settings” screen.
Only admin can change settings. If you add other user names they can only see video without changing
anything.
If you forget your password you can always reset your camera to factory settings using the reset procedure shown
at the end of this manual.
To Next Page
Loading...
