ASSEMBLY STEPS
STEP 3: SEAT POST, SLIDING TUBE COVER,
CUSHION, AND SLIDING TUBE
INSTALLATION
Remove 3 x Flat Washer (66) and 3 x Nylon Nut (65)
from underside of the Seat Cushion (46). Guide bolts
on underside of the Seat Cushion (46) through holes
on top of the Seat Slider (7), attach with removed
3 x Flat Washer (66) and 3 x M8 Nylon Nut (65).
Tighten nylon nuts with Multi Hex Tool with Phillips
Screwdriver provided.
Attach the Seat Slider (7) to the Seat Post (5) with
Knob (50) by turning it in a clockwise direction to
lock the Seat Slider (7) in the suitable position.
Insert the Seat Post (5) into the Seat Post Plastic
Bushing on the tube of the Main Frame (1) and then
attach the M16 Seat Height Adjustable Knob (51)
onto the tube of the Main Frame (1) by turning it in
a clockwise direction to lock the Seat Post (5) in the
suitable position.
Turn the M16 Seat Height Adjustable Knob (51) in a
counterclockwise direction to release the Seat Post
(5) and then slide the Seat Post (5) up or down
slightly to the desired hole for the suitable position.
Lock the Seat Post (5) in place by tightening the Seat
Height Adjustable Knob (51) in a clockwise direction.
To adjust the Seat Back and Forth, turn the
Knob (50) in a counterclockwise direction to release
the Seat Slider (7) and then slide the Seat Slider (7)
back or forth slightly to the desired hole for the
suitable position. Lock the Seat Slider (7) in place by
tightening the Knob (50) in a clockwise direction.
NOTE: When adjusting the height of seat post, make
sure the seat post plastic bushing does not exceed
the marked line on the seat post.
STEP 3
66
65
50
7
46
5
1
3
51
TOOL:
Multi Hex Tool with Phillips Screwdriver
S13, S14, S15
To Next Page
Loading...
