Trojan Iginte 370 - MAINTENANCE: Lubrication Procedures; MAINTENANCE: Belt Tracking

23
10334
MAINTENANCE
HOW TO APPLY LUBRICANT
• Lift one side of the running mat.
• Pour one half of the lubricant bottle under the centre of the running mat on the top
surface of the treadboard.
• Walk on the treadmill at a slow speed for 3 to 5 minutes to evenly distribute lubricant.
• NOTE: DO NOT over lubricate treadboard. Any excess lubricant that comes out should
be wiped off.
• NOTE: ONLY USE HALF THE BOTTLE OF LUBRICANT PER APPLICATION.
• NOTE: If your lubricant is nished, the treadbelt can be lubricated with Dubbin.
LUBRICATION SCHEDULE
• Check the treadboard lubrication during installation. If it’s necessary, lubricate the
treadboard using one half of the lubricant provided, before using the treadmill for the
rst time.
• If the treadmill is used on a regular basis, the running deck should be lubricated once a
month.
• If the treadmill is not used for two months or more, the treadboard must be lubricated
before use.
BELT TRACKING ADJUSTMENT
• If during use you notice that the running deck
either shifts to the right or the left of centre,
switch off the treadmill, remove the “Safety Key”
and unplug the equipment from the AC power
source.
• If the running deck shifts left, using Allen wrench
provided, turn the left rear roller adjustment
clockwise no more than 1/4” of a turn (if
the running belt shifts right, adjust the right rear
roller).
• Remove the Allen Key, insert the “Safety Key”
and insert the AC power cord into the
AC outlet. Turn on your treadmill and observe
after running for a few minutes to see if
the problem has been corrected.
• This may take several adjustments, so repeat the
above procedure.